- Front wheel not spinning freely | Honda CBR 600RR Forum.
- Rear wheel spinning in neutral while on stand? motorcycles.
- Rear wheel doesn#x27;t spin freely | AnandTech Forums: Technology, Hardware.
- What does this mean? 1 front wheel spins freely, one doesnt.
- Rear wheel wont freely spin - ProBoards.
- Wheel spinning when clutch is pulled in... - Horizons Unlimited.
- Rear Wobble Harley Tire.
- Should the front wheel spin freely?? - Bike Chat Forums.
- Clutch engaged and tire doesn#x27;t spin freely? - Kawasaki Ninja ZX-6R Forum.
- SOLVED: My rear wheel doesn't spin freely after I had to.
- Rear wheel won#x27;t freewheel - YZ400F/426F/450F/450FX - ThumperTalk.
- Axle nut torque specs | Motorcycle Forum.
- Should the front wheel spin freely on a jacked-up bike?.
- Why does the Motorcycle does A Wheelie when you Clutch... - Physics Forums.
Front wheel not spinning freely | Honda CBR 600RR Forum.
Yes, something isn't turning freely. It's either the front wheel, the back wheel, or the pedals and chain. Lift the bike off the ground and turn the front wheel by hand. If it doesn't turn very freely, it could be the hand-brake is dragging or the hub bearing is.
Rear wheel spinning in neutral while on stand? motorcycles.
Also, at least for my 250, you had to make sure the speedometer housing was installed correctly about a 20 degree range, otherwise the wheel wouldn#x27;t spin properly; make sure you#x27;re installing that correctly. It may be different on the 500, but the bikes are very similar, so I would doubt it: 250 Front Wheel Install Guide.
Rear wheel doesn#x27;t spin freely | AnandTech Forums: Technology, Hardware.
There is no way to establish a parameter for that. There are too many variables. Put a finger on the axle end and spin the wheel. If you feel a rumble, replace the bearings. Disc brakes do not retract. The seals may put a slight pressure on the pistons but it#x27;s the variations in the rotor that push the pads back. First thing that happens... the plastic chain guard on the rear sprockets that keeps the chain from going into the spokes breaks. It gets lopsided and starts rubbing so I cut it out of there. Now the rear wheel does not spin freely. If I pick the rear wheel off the ground and spin it in the forward direction the pedals sort of tick forward.
What does this mean? 1 front wheel spins freely, one doesnt.
One thing to check is to see if the axle is bent. This will cause the wheel to pulse, be loose, and bind. The bent axle could also be rubbing on the freewheel. If the axle is smooth by hand but the wheel does not spin freely, the freewheel could be gummed up. The solution for this is dripping a light oil like T9 some people prefer Triflow, but. 75#x27; r75/6 with a single front disk, btw. I can turn the rear by hand but the wheel doe not spin around after I let go of the tire. Front feels free and will spin about a quarter turn after I spin it. The wheel spun freely till i tightened the axle nut I hand tightened and no additional binding after I wrenched it.
Rear wheel wont freely spin - ProBoards.
I noticed the rear wheel on my 1990 Honda elite 80 was locked. will spin about 10 of a full turn. It WILL spin if you apply the throttle. I dont believe it to be the brakes. I applied the back brake and it stops it from spinning the 10 that it will spin without the brake applied. Its as if the scooter is stuck in quot;engagedquot; mode and will not.
Wheel spinning when clutch is pulled in... - Horizons Unlimited.
2. Inside your rear wheel is what is called a free hub. It has a ratcheting mechanism that allows you to pedal backwards while conversely engaging when you pedal forward so to transfer pedal force to the wheel. I#x27;ve been stuck on a trail more than once due to a free hub failing to engage. Unfortunately your free hub is generally not servicable. Jan 13, 2015. #1. I just changed the chain and sprockets on my '02 YZ426F and the rear wheel doesn't spin so great with the bike on the stand. Maybe half a turn when I try to spin it by hand. The chain is within spec while on the tighter side, axle is straight and the pads are dragging a little bit but not a lot. Yes, several months ago we had a discussion about rust forming on the rotors of the rear wheels and the brake pads fusing to the rotor. The result was that the rear wheels would not rotate. Of course it may also be that the brake pads are set but that is rather obvious. Take a look at the rotors on the rear and see if you can see a rust build up.
Rear Wobble Harley Tire.
Tire wobble most often originates in the tires themselves: One tire problem leads to another until it creates a wobble Now, my tires are approaching 20,000 miles and rear tire is getting bald 1948 - 1956 F1, F100 amp; Larger F-Series Trucks - Rear Wheel wobble - Left rear wheel has a noticeable wobble Cutting and welding your frame permanently changes your motorcycle, this almost always instantly.
Should the front wheel spin freely?? - Bike Chat Forums.
Also if the noise is so loud it wont be long till the failure happens. It may also be a the rear brake binding. You can do a simple test by raising the rear wheel clear off the ground and rotating it binding brakes will be obvious as the wheel will not spin freely. This also applies to test for bearing wear as you will hear the noise coming.
Clutch engaged and tire doesn#x27;t spin freely? - Kawasaki Ninja ZX-6R Forum.
After the install, I tried to spin the front wheel with the bike on stand and there was some drag. The wheel doesn#x27;t spin freely as it did before with the old brake pads...basically doesn#x27;t complete one full rotation when spun with hand. I checked the brake fluid level and it is between low and high, I removed the pads, cleaned the pistons. Search: Harley Rear Tire Wobble. On some trikes I have ridden they seem to have a tendency to wobble if your lugging the engine Therefore, I misalign the wheel by about 3mm, which is just enough to let the belt drift out 7 L PSD Crew Cab Dually, FX4, white platinum metalic tri-coat with black interior, N-Fab step bars, factory spray-in bedliner and 5th wheel hitch, trailer tow package. If it doesn#x27;t spin freely with weight on it, that#x27;s fairly normal. you might benefit from adjusting the cable tension a bit but my experience says that it#x27;s nothing to worry about piecepatrol99 Member Joined Aug 29, 2014 Messages 77 Oct 22, 2014 #3 I had a similiar issue when my clutch cable frayed and jammed inside the sleeve.
SOLVED: My rear wheel doesn't spin freely after I had to.
Maximum torque is 45 lbs/feet. You want to rotate the wheel and turn the nipples a little at the time while observing the run out. I don#x27;t use fancy equipment. My favorite pointer is a wooden paint stirring stick. It#x27;s cheap, it doesn#x27;t scratch, and I simply clamp it to the leg of my balancer and spin the wheel. I recently ran over a nail and needed a new tire. I got the wheel off fine, but when replacing the wheel, two things have me a little unsure. First, If I torque the rear axle nut to 47lb/ft it will not spin very freely at all. If I back it off to about 38. Rear wheel spinning in neutral while on stand? This may be a dumb question, but I have my bike - 2012 Yamaha FZ8 - on the stand both wheels off the ground, and I turned on the engine while in neutral, and I noticed that the rear wheels spins pretty slowly - my hand was off the clutch.
Rear wheel won#x27;t freewheel - YZ400F/426F/450F/450FX - ThumperTalk.
Experiment by loosening the lock nut on the other end from the quick release mechanism. Just a little at a time until the wheel turns as easily as it did before. Check the wheel. Then check that the wheel is held properly, try to knock it out, or try to move the rim from side to side, watching the hub to see if it is moving in the frame ends. With the calipers OFF the wheel, it should spin quite a few times. But there is always a tiny bit of friction between the pads and rotors, which will slow down the wheel at slow speeds. K kevin_stevens Mediocre Strafer Joined Aug 20, 2006 9,137 Posts #12 Mar 30, 2009 If they are just dragging lightly while spinning, they#x27;re supposed to do that. It should spin freely and smoothly and stop immediately when the rear brake pedal is pressed. Also watch the spinning wheel from behinddoes it have a #x27;wobble#x27; or #x27;run out#x27; while it spins? This can probably be corrected on a spoked wheel, but on an alloy wheel might indicate it is bent, and this is harder to correct.
Axle nut torque specs | Motorcycle Forum.
Take the calipers off and spin wheel - with a felt pen - mark the high spots... If something hit could be bent... You straighten with a very large adj. wrench to pull it a ruber mallet to knock it down... Use solvent to remove pen be done in 10 min. or less... R Ratbelly Premium Member Joined Apr 22, 2004 286 Posts. Prying didn#x27;t help. Prying and hitting the side popped it loose and it moved back into position with no further problems. Wheel is spinning freely as it should. Rode it a bit trying to find a place that had a replacement screw for the brake reservoir, found one!, everything seems ok now.
Should the front wheel spin freely on a jacked-up bike?.
Slide the balancing stand#x27;s axle through the wheel, insert the centering cones into the wheel bearings and secure the cones in place. Step 5. Place the wheel into the balancing stand, and make sure it spins smoothly and freely. Step 6. Gently spin the wheel so it rotates a few times and gradually comes to a halt. A properly-functioning caliper on a 550 should NOT DRAG AT ALL. I can spin the front wheel on both of mine and they spin freely until I touch the brake. Keep riding it like it is and you#x27;re going to overheat and warp your brake rotor. Make sure the REAR wheel bearings exhibit no side-play whatsoever. Answer 1 of 3: A chain, driveshaft or belt will present some significant variation in effort. Also the type of brakes and the effective radius of the friction material. So the request for the minimum will cover a relatively wide range of force, though all will be small values. You may find tha.
Why does the Motorcycle does A Wheelie when you Clutch... - Physics Forums.
Now when I turn the wheel it does not spin as freely as it did before. It only turns about one revolution, where as before it would spin almost twice as much. I took the bike for about a 10 mile ride, and let the pads #x27;bed in#x27; and the disks are not getting hot, but still the wheel does not spin freely. Any comments or suggestions. Search: Harley Rear Tire Wobble. 25 wheel with the 200/55-17 tire from one of the brands listed above This 23quot; tree kit is guaranteed to give you a smooth, wobble-free ride Bold, angled lateral grooves in the tread pattern helps evacuate water away from the contact patch I have a ram 2500 Hemi QC with 315/70/17#x27;s and a 2 Inch leveling kit When rear end packs in, tires generally will overheat. I continued to spin my rear wheel and still it did not spin freely. I replaced with my old stock wheels for a comparison and they continued spinning for well over a minute before I stopped them.... but 7-10 seconds for a rear wheel doesn't sound outrageously tight to me. There are 4 rather large bearings. 0. llen Posts: 65. June 2015. Crikey.
See also:
